Raft Frames and Parts

Make sure to check your frame pipe size either LD (1.25in) or XD (1.5in). 

The platform is made from our 3/4" high-density polyethylene (HDPE) material. The raised pattern slip-resistant surface gives you excellent footing, even when wet.
HDPE doesn't absorb water, is low maintenance and perfect for your fishing adventures.

Maximize your frame length with the right size of Side Rails.
The forged aluminum NRS LoPro™ Frame Fitting on cross bars, seat bars and foot bars let you locate these pieces anywhere along the Side Rails.

These adjustable pegs allow a rower to lock his toes under the pegs while bracing with their foot on the drop bar.

The Otter Fishing Dodger XL and E-139D Dodger XL make great fishing rafts. This Dodger Stern Seat Mount is designed to put your angler in the best balanced position in these boats.

The soft cushion is covered with a tough vinyl used in tractor seats. Your back will love the support you get from the high seat back. Strong plastic construction in the supportive seat pan eliminates metal parts that could rust or bend.

The Rear Casting Platform comes in two sizes. The Large is sized for the rear compartment of rafts taking a frame 60" or wider. The Small fits in boats with a 54" or narrower frame.
The platform is made from our 3/4" high-density polyethylene (HDPE) mate

The Stern Side Rails attach to your frame using our LoPro™ Frame Fittings, which are designed to clamp to our 1 5/8" diameter frame pipe.

Strap dry bags, ammo cans, tackle boxes, Pelican cases, anything you can think of, to your Side Rail Racks. The racks are made with an 8 inch by 3-, 4- or 6-foot piece of 3/4 inch high-density polyethylene (HDPE) plastic.

Attaches on both sides directly to a seat bar, raised seat bar, or a cross bar using LoPro™ Frame Fittings. The Small fits on frames 54" wide or smaller. The Large fits on frames 60" wide and larger.

A strip of neoprene covers the nylon, protecting it from UV and abrasions. Colored Pennel Orca® is glued on top to complete the patch. D-Rings are stainless steel, and available with 4.5", 6" or 8" patches. (8" patches are good for replacing D-Rings that

Stainless steel U-bolts for NRS LoPro Frame Fittings and other frame accessories.